CISCO 2950 SWITCH DATASHEET HOW TO

In this procedure we will assign fastethernet0/18 as our trunk link. Tenth we also need to create a trunk link that will serve as a link to other device in the network. Setting device VLAN database password to rulesДЎ0.

Ninth add a VTP password of rules to the switch such as. Eight change the vtp domain to the name of your choice.Д¬hanging VTP domain name from NULL to JeremyД©. By default a Catalyst switch is a VTP server.ДЁ. Seventh we need to configure our switch as a VTP server or a client if there is another switch. VLAN Type SAID MTU Parent RingNo BridgeNo Stp BrdgMode Trans1 Trans2Д§. Sixth to verify our VLAN configurations we need to see it by using the Show VLAN command.ДЎ default active Fa0/1, Fa0/10, Fa0/11, Fa0/12ДЎ0 VLAN0010 active Fa0/2, Fa0/3, Fa0/4, Fa0/5ДЎ6 VLAN0016 active Fa0/6, Fa0/7, Fa0/8, Fa0/9 Switch1(config-if-range)#switchport access vlan 16Д¦. Switch1(config)#interface range fastethernet0/6-9 Fifth assign ports to VLAN 16 starting from ports fastethernet0/6 to fastethernet0/9. Switch1(config-if-range)#switchport access vlan 10ДҐ. Switch1(config)#interface range fastethernet0/2-5 Fourth we need to assign ports starting from port fastethernet0/2 to fastethernet0/5 to VLAN 10. Please consult userДocumentation for configuring VTP/VLAN in config mode.Д¤. % Warning: It is recommended to configure VLAN from config mode,ДЄs VLAN database mode is being deprecated. Third we need to add VLAN 10 and VLAN 16 to the switch. %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to upДЈ. %LINK-5-CHANGED: Interface Vlan1, changed state to up After giving the switch a host name we proceed with assigning an IP address to the VLAN1 of the switch. %SYS-5-CONFIG_I: Configured from console by consoleДў. First we need to assign a host name to the switch.Д®nter configuration commands, one per line.

CISCO 2950 SWITCH DATASHEET HOW TO

Our topic for today will focus on how to configure the VLAN on a Catalyst 2950 Series Switch.ДЎ.

Cisco 2950 switch datasheet